Circutor DHB Series Uživatelský manuál stáhnout pdf (Strana 29)

The measurement of the minimum times of duration of impulses is checked when both times t_L and t_H are  0,25 ms

The measurement of the minimum times of duration of impulses is checked when both times t_L and t_H are  5 ms

The setting AUTO1 to a value, which is out of range shown in the table will result in setting upper value of the range

as the time of the measurement

When ConS1 < 0 pulse counting direction are reverse.

You should give the signal on W1 to counting the time of the work near turned on external functions.

For ConS1 < 0 the worktime counter count down

HoUr Current time Not used Not used – – – – – –

EnC

Measurement of

encoder position

Measuring

input

Mount pulses

up for

WE3 = 1

Count down for

WE3 = 0

+ + +

–

The crossing

the value

AUTO will

cause

automatic

erasing

Inputs and worktime counters parameters The value of counters after reset /

Worktime value after reset, In mode measurement

worktime for main counter

Value CONS1, CONS2 Value AUTO1, AUTO2

CONSn > 0 AUTOn  0

CONSn > 0 AUTOn < 0

AUTOn

CONSn < 0 AUTOn > 0

AUTOn

CONSn < 0 AUTOn  0

Table 8a

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Žádné komentáře

Circutor DHB Series Uživatelský manuál Strana 29