Circutor DHB Series Uživatelský manuál stáhnout pdf (Strana 19)

2) setting of the decimal point position (00000., 0000.0, 000.00, 00.000,

0.0000); the button shifts the decimal point to the left, howe-

ver the button shifts the decimal point to the right;

The pressure of the button during the change of the parameter

value will cause the resignation of the write.

Table 1

InP 1

Para-

meter

symbol

Description Range of changes

tYP1

Selection of measured value

Cntr – number of pulses

FrEqL – frequency for

(f < 10 kHz)

FrEqH – frequency for

(f > 10 kHz)

tACH – rotational speed

PEr – period

PErH – long period > 10 s.

CntH – worktime counter.

Hour – current time

Enc – incremental encoder

SCAL1

Selection of input quantity rescaling. Mea-

sured value is multiplied or divided by the

set point value (parameter ConS).

And – multiplication by the

constant

diu – division by the constant

ConS1

Constant rescaling the input quantity.

The write of a negative value causes

the counting down (mode of pulse

counter and worktime counter).

-19999...99999

t_L1

Minimal duration time of the low level

pulse on the main input. The intro-

duction of a value lower than 0.25 or

5 causes the switching of the length

control function of the low signal level

off. The value is given in milliseconds.

0...60000

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 57 58

Komentáře k této Příručce

Žádné komentáře

Circutor DHB Series Uživatelský manuál Strana 19

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Circutor DHB Series