Circutor MDC-4 Uživatelský manuál stáhnout pdf (Strana 21)

Press key to access the next programming step.

4�8�6� Deleting the energy value

Clea Energy

In this step you select whether or not to delete

the energy value.

Press the

button to select between the two

possible options: No or Yes.

Press key to access the next programming step.

4�8�7� Deleting the output relay disconnection times�

Clea

out % Time

In this step you select whether or not to delete

the % of time that each output relay has been

disconnected.

Press the button to select between the two

possible options: No or Yes.

Press key to access the next programming step.

4�8�8� Level of output relay no� 1

out1 Level (%)

In this step you program the value (%) of con-

tracted power from which the output relay is

disconnected.

Example: If OUT1 is programmed to 75%, when the maximum demand value reaches 75%

of the contracted power in the installation, output relay no.1 will be disconnected, thus discon-

necting all the corresponding loads.

Press the key to increase the digit that is currently ashing.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the remaining values.

Maximum value: 99%.

Minimum value: 0 %.

Default: OUT1 : 75% , OUT2 : 80%, OUT3 : 90%, OUT4 : 95%

Press key to access the next programming step.

4�8�9� Hysteresis of output relay no� 1

out1 Hyst (%)

The hysteresis value, i.e., difference between the

relay connection and disconnection point, in %,

is programmed in this step.

Press the

button to increase the digit that is

currently ashing.

Instruction Manual

MDC-4

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Komentáře k této Příručce

Žádné komentáře

Circutor MDC-4 Uživatelský manuál Strana 21

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Circutor MDC-4