LV CAPACITOR BANKS WITH DETUNED FILTERS AND STATIC SWITCHING FRE / FRES INSTRUCTION MANUAL (M98247101-03-12A)
FRE / FRES 10 / 20 4.6.3 Power block: The power block of FRE or FRES units is made up of 3 to 12 thyristors + capacitor groups, depending o
FRE / FRES 11 / 20 5.3.1 Power circuit. • Connect input terminals L1, L2 and L3 (power circuit) to the grid using proper sized cable in accor
FRE / FRES 12 / 20 5.3.5 Connecting the current transformer (CT) An external current transformer (CT) must be installed to measure the tot
FRE / FRES 13 / 20 Fig. 5-4 .- Jumper for short-circuiting the secondary winding of the current transformer (CT). Any time you wish to c
FRE / FRES 14 / 20 Fig. 6-1 .- Computer Max f Regulator (Picture provided as an example. It may not coincide with the model used on your unit
FRE / FRES 15 / 20 7 MAINTENANCE 7.1 Safety regulation SAFETY Apply the safety regulations listed in section 2 of this manual before operat
FRE / FRES 16 / 20 • In dirty environments (dust, sawdust, metal trimmings, etc.). Vacuum the dust and solid remains regularly. There is no es
FRE / FRES 17 / 20 - Check that the steps connect and disconnect properly - Check that there is no consumption in any phase with the step di
FRE / FRES 18 / 20 8 WARRANTY CIRCUTOR guarantees its products against any manufacturing defect for two years after equipment delivery. C
FRE / FRES 19 / 20 9.1 Conformity declaration
FRE / FRES 2 / 20 SYMBOLS AND WARNINGS Pay attention to the danger and warning indications in this manual, which are shown with the following
FRE / FRES
FRE / FRES TABLE OF CONTENTS 1 INTRODUCTION ...
FRE / FRES 4 / 20 1 INTRODUCTION The purpose of this manual is to assist during the installation, start-up and maintenance of FRE and FR
FRE / FRES 5 / 20 2.3 Application warnings Capacitor banks with detuned filters can attenuate the remote control signals transmitted through
FRE / FRES 6 / 20 forks must be flat and laid firmly on the base. The cabinet must be raised by placing the forks underneath the profile that s
FRE / FRES 7 / 20 4.2 Electrical characteristics - Operating voltage and nominal frequency: Un / f , listed on the label - Design voltag
FRE / FRES 8 / 20 4.5 External dimensions and weights Fig. 4-2. - Dimensions (*) Maximum dimensions 4.6 Capacitor bank componen
FRE / FRES 9 / 20 NOTES: • Some elements of protection shown in Fig. 4-3 are optional and may not be present in your equipment • In FRES equipm
Komentáře k této Příručce